Lectrosonics UT200 Bedienungsanleitung Seite 1

UT200 FREQUENCY-AGILE HAND-HELD TRANSMITTER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

ADJUSTING THE TRANSMITTER FREQUENCY If you are experiencing interference from another signal on your frequency, you may want to change the

Frequency Agile Handheld Transmit-ter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitte

SPECIFICATIONS Operating Frequencies: 486.4 to 588.7 and 614.4 to 793.6 MHz RF Power Output: 100mW Pilot Tone: 32.765 kHz, ±2 Hz, 5kHz deviation

Frequency Agile Handheld Transmit-ter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the tro

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided i

INTRODUCTION Thank you for selecting the Lectrosonics UT200 hand-held wireless transmitter. The UT combines over 80 years of engineerin

Frequency Agile Handheld Transmit-ter GENERAL TECHNICAL DESCRIPTION The UT200 transmitters are comprised of a number of functional su

control the audio output muting of the receiver. The pilot tone is filtered out of the audio signal immediately after the de

Frequency Agile Handheld Transmit-ter CONTROLS AND FUNCTIONS EXTERNAL “P” SWITCH – POWER ON/OFF Audio Power A slide sw

Internal Controls - VariMic Version The VariMic head includes adjustments for Bass, Midrange and Treble response.

Frequency Agile Handheld Transmit-ter Note: The attenuator should not be used as a level control. The Audio Level control inside the battery compart

BATTERY INSTALLATION The transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY ALKALINE

Frequency Agile Handheld Transmit-ter OPERATING INSTRUCTIONS 1) Install a fresh battery according to the instructions on p