Lectrosonics T1 Bedienungsanleitung

T1 INSTRUCTION MANUAL Multi-Frequency IFB Transmitter Fill in for your records: Serial Number: Purchase Date: Rio Rancho, NM, USA www.lectrosonics.c

T1 Operating Notes The AUDIO LEVEL control should not be used to control the volume of the associated receiver. This gain adjustment is used to

Multi-Frequency IFB Transmitter Troubleshooting Symptom: Possible Cause: Display Dead or Blinking On and Off 1) External power supply disconnected

T1 Frequency Blocks and Ranges The table below lists the factory designated frequency ranges available for the T1 IFB Transmitter. Each T1 t

Multi-Frequency IFB Transmitter Specifications Operating Frequencies: Block 21 537.600 - 563.100 Block 25 640.000 - 665.500 Block 22 563

T1 Service and Repair If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipme

Multi-Frequency IFB Transmitter Rio Rancho, NM 15

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provid

T1 LECTROSONICS, INC. 2

Multi-Frequency IFB Transmitter Table of Contents Introduction ...

T1 Introduction Thank you for selecting the Lectrosonics frequency agile, narrowband, T1 IFB (Interruptible Foldback) transmitter. The T1 is the

Multi-Frequency IFB Transmitter General Technical Description The T1 IFB Transmitter is comprised of a number of functional subsystems, includi

T1 Pilot Tone The T1/R1A system uses an ultrasonic tone modulation of the carrier to operate the receiver squelch. This “pilot ton

Multi-Frequency IFB Transmitter Front Panel Controls and Functions T1 Front Panel OFF/TUNE/XMIT Switch OFF Turns the unit off

T1 Rear Panel Controls and Functions T1 Rear Panel XLR Jack A standard XLR female jack accepts a variety of input sourc

Multi-Frequency IFB Transmitter Installation and Operation 1) The T1 transmitter is shipped with pin 1 of the XLR input connector tied direc