Lectrosonics H175DC Bedienungsanleitung Seite 1

H175DC Plug-On Transmitter OPERATING INSTRUCTIONS and trouble-shooting guide Digital Code Squelch LECTROSONICS, INC. Rio Rancho, NM

SPECIFICATIONS AND FEATURES Operating frequencies: 169 to 172 MHz; 174 to 186 MHz RF Power output: 50mW Deviation: ±15kHz Spurious radiation: 55d

Plug-On Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

This page intentionally blank. 2

Plug-On Transmitter INTRODUCTION Thank you for selecting the Lectrosonics Professional Series wireless microphone system. This system represents well

GENERAL DESCRIPTION The H175DC is a “plug-on” transmitter that converts any microphone with an XLR connector to wireless operation. The transmitter i

Plug-On Transmitter CONTROLS AND FUNCTIONS The H175DC may be used with a wide variety of microphones. The 3-pin XLR type connector on the H175DC all

OPERATING INSTRUCTIONS 1) Install the Microphone onto the transmitter. a. Unscrew the collar by turning it fully clockwise until it stops. Lock

Plug-On Transmitter 2) Turn on the receiver and adjust the output level to minimum. 3) Turn on the transmitter. The CODE LED on the receiver

BATTERY REPLACEMENT The H175DC transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY an ALKA-LINE battery

Plug-On Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is importan