Lectrosonics UM110 Bedienungsanleitung

UM110 UHF MULTI-FREQUENCY BELT-PACK TRANSMITTER EURO MODEL OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. www.lectrosonic

MICROPHONE CORD TERMINATION 1 2 3 45 VIEW FROM SOLDER SIDE OF PINS 0.3" 0.15" Heatshrink Tubing TA5F Connector Assembly Mic Cord Stripping

Multi-frequency UHF Belt-Pack Transmitter ters. 5-PIN INPUT JACK WIRING The wiring diagrams shown on the next page represent the basic wiring necessa

PIN 5 High impedance, line level input for tape decks, 2 WIRE MIC 3 WIRE MIC mixer outputs, musical instruments, etc. RF BYPASSING Some mics requi

Multi-frequency UHF Belt-Pack Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transm

SPECIFICATIONS AND FEATURES Operating frequencies:  Frequency selection:  Channel spacing: 

Multi-frequency UHF Belt-Pack Transmitter This page intentionally blank. Rio Rancho, NM – USA 15

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

TABLE OF CONTENTS INTRODUCTION ... 3 GENERAL TECHNIC

Multi-frequency UHF Belt-Pack Transmitter INTRODUCTION Thank you for selecting the Lectrosonics UM110 multi-frequency, belt-pack transmit-ter. The U

GENERAL TECHNICAL DESCRIPTION The UM110 transmitters are comprised of a number of functional sub-systems as shown in the block diagram below. GENERAL

Multi-frequency UHF Belt-Pack Transmitter PRE-EMPHASIS/DE-EMPHASIS The signal to noise ratio of the 110 system is extended by using pre-emphasis (HF b

CONTROLS AND FUNCTIONS ANTENNA OFF ON –20 0 LECTROSONICS LEVEL AUDIO UM 110 FREQUENCY COURSE FINE 0123456789ABCDEF0123456789ABCDEF0 1 2 3 4 5 6 789A

Multi-frequency UHF Belt-Pack Transmitter FREQUENCY ADJUST These two rotary switches adjust the center frequency of the carrier. The left switch is

BATTERY INSTALLATION The transmitter is powered by a standard alkaline or lithium 9 Volt battery. It is important that you use ONLY an ALKALINE or L

Multi-frequency UHF Belt-Pack Transmitter OPERATING INSTRUCTIONS 1) Install a fresh battery according to the instructions above. 2) Insert the micr