Lectrosonics M187 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Kommunikationszubehör Lectrosonics M187 herunter. Lectrosonics M187 User Manual [en] Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
M187
BELT-PACK TRANSMITTER
OPERATING INSTRUCTIONS
and trouble-shooting guide
LECTROSONICS, INC.
Rio Rancho, NM
Seitenansicht 0
1 2 3 4 5 6 ... 13 14

Inhaltsverzeichnis

Seite 1 - LECTROSONICS, INC

M187 BELT-PACK TRANSMITTER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

Seite 2 - INTRODUCTION

RF BYPASSING 2 WIRE MIC 3 WIRE MIC Some mics require RF protection to keep the radio signal from affecting the capsule, even though the transmitter

Seite 3 - Belt-Pack Transmitter

Belt-Pack Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter the red pow

Seite 4 - CONTROLS AND FUNCTIONS

SPECIFICATIONS AND FEATURES Operating frequencies: 150 to 216 MHz RF Power output: 50 mW Deviation: ±15kHz (max) Spurious radiation: 55 dB below

Seite 5

Belt-Pack Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the

Seite 6 - BATTERY REPLACEMENT

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

Seite 7

INTRODUCTION Thank you for selecting the Lectrosonics M187 transmitter. This transmitter repre-sents over 70 years of combined experience in the

Seite 8 - MICROPHONE CORD TERMINATION

Belt-Pack Transmitter GENERAL TECHNICAL DESCRIPTION The M187 transmitter is comprised of four major functional subsystems: the input compressor, t

Seite 9 - M187 INPUT JACK WIRING

CONTROLS AND FUNCTIONS LECTROSONICS M187 ON MUTE OFF LEVEL LIMIT MIC LEVEL INPUT JACK The input on the M187 accommodates virtually every lavalier,

Seite 10 - 2 WIRE MIC 3 WIRE MIC

Belt-Pack Transmitter Since the internal circuits are all tightly regulated and the RF output stage has a separate discrete regulator, the transmitter

Seite 11 - TROUBLESHOOTING

BATTERY REPLACEMENT The M187 transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY an ALKA-LINE battery fo

Seite 12 - SPECIFICATIONS AND FEATURES

Belt-Pack Transmitter OPERATING INSTRUCTIONS 1) Insert the microphone plug into the input jack, aligning the pins; be sure that the connector lock

Seite 13 - RETURNING UNITS FOR REPAIR

MICROPHONE CORD TERMINATION 1 2 3 45 VIEW FROM SOLDER SIDE OF PINS 0.3" 0.15" Heatshrink Tubing TA5F Connector Assembly Mic Cord Stripping

Seite 14 - LIMITED ONE YEAR WARRANTY

Belt-Pack Transmitter M187 INPUT JACK WIRING The wiring diagrams shown on the attached sheet represent the basic wiring necessary for the most

Kommentare zu diesen Handbüchern

Keine Kommentare